Stratasys uPrint, Service Manual, Page: 292 / 383

uPrint/uPrint SE Service Manual 6-25
3.0 Non-Code Errors
A.
“Build Error” displayed on LCD
B.
Tip Depth Incorrect
C.
“Corrupted Upgrade” displayed on LCD
D.
“Carrier Invalid or Empty” displayed on LCD
E.
Door Latch
F.
“Door Open” displayed on LCD
G.
Download
H.
Loss of Extrusion (LOE)
I.
Lights
J.
Material/Unload Error (failed to load/unload material)
K.
Network Communications
L.
Pauses during build
M.
Power down
N.
Power Up/Boot
O.
“Can’t Find Home - Check Modeling Base” displayed on LCD
P.
System VERY slow to reach temperature
Q.
Calibration issues
R.
Unexpected behavior
S.
Z Calibration failure
T.
Noise
50.
A. “Build Error” displayed on LCD
Part stops building before complete.
1. Partial or bad model file sent to unit. - Check and reprocess the
STL and re-download
B. Tip depth is incorrect
Tip Depth is wrong (too deep or above the
modeling base)
1. Run Z tip calibration.
2. Check and/or clean the Z foam sensor.
3. Replace the Z foam assembly and sensor
C. “Corrupted Upgrade” Displayed on LCD
1. Verify the CD is the correct gender. (Same as the system)
2. Cycle power and try download again. If not possible or fails
again replace hard drive.
3. Verify the hard drive and the controller board are gendered
correctly.