Stratasys uPrint, Service Manual, Page: 29 / 383

2-18
Printer overview
uPrint SE and uPrint SE Plus build models from CAD STL files. The printer builds three-
dimensional parts by extruding a bead of ABS material through a computer-controlled
extrusion head, producing high quality parts that are ready to use immediately after
completion.
uPrint SE and uPrint SE Plus consist of two primary components — the 3D printer and
material bay. Catalyst
® EX is the preprocessing software that runs on Windows XP Pro,
Windows Vista or Windows 7 platforms.
uPrint and uPrint SE build a maximum part size of 203 x 152 x 152 mm (8 x 6 x 6 in). uPrint
Plus and uPrint SE Plus build a maximum part size of 203 x 203 x 152 mm (8 x 8 x 6 in). Each
uPrint and uPrint Plus material carrier contains 492 cc (30 cu. in.) of usable material —
enough to build continuously for about 48 hours without reloading. Each uPrint SE and
uPrint SE Plus material carrier contains 688 cc (42 cu. in.) of usable material — enough to
build continuously for about 67 hours without reloading. You can add an optional second
material bay for extended build times.
Figure 2-10: Front and left side view of printer.
1 Display Panel 4 Optional Material Bay, Model Side
2 Material Bay, Support Side 5 Material Bay, Model Side
3 Optional Material Bay, Support Side 6 Power ON/OFF Switch
Front view
2
3
4
5
1
6