Stratasys uPrint, Service Manual, Page: 21 / 383

2-10
Figure 2-4: Controller board connection detail
Reset Button
Located on the lower right side of the board, the reset button will do a hard reset of the
controller board. Before continuing with normal operation after resetting the board, system
power must be cycled before building. The reset button should only be used after using
TeraTerm.
Dip Switches
There are three dip switch banks (SW2, SW5, SW6) located on the top right side of the board.
Dip switches are factory set and should not be changed unless noted to be in another
position.
SW2
SW5
Number (in white) Description Default
16-24 Unused Off
Number (in white) Description Default
8-15 Unused Off