Stratasys uPrint, Service Manual, Page: 129 / 383

4-82
TC Amp board
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver
•
1
⁄
4
” nut driver
Hardware
• 10-32 x
3
⁄
8
” slotted screws (x7)
• 6-32 x
1
⁄
4
” slotted screws (x3)
Removing the TC Amp board
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Remove the right side access panel mounting screws with a
5
⁄
16
” nut driver or standard
screwdriver and remove the panel. See Figure 4-139.
Figure 4-139: Right side access panel mounting screw locations
4.
Disconnect the umbilical cable by pressing in on the tab and pulling outward. See Figure
4-140.
Remove the 7
mounting screws.