Stratasys uPrint, Service Manual, Page: 111 / 383

4-64
Substrate Sensor
Required Tools
•
5
⁄
16
” nut driver or standard screwdriver.
•
3
⁄
32
” allen wrench.
Hardware
• Wire tie (x1)
• 10-32
x
3
⁄
8
” slotted screws (x7)
• 4-40 x
1
⁄
4
” slotted screws and # 4 split lock washer (x4)
Removing the substrate sensor
1.
Remove the top panel. See Removing the top panel on page 4-5.
2.
Remove the side panels. See Side Panels on page 4-7.
3.
Using a
5
⁄
16
” nut driver, remove the 7 right side access panel mounting screws. See
Figure 4-107.
Figure 4-107: Right side access panel mounting screw locations
4.
Disconnect the substrate sensor wire from the head board by pressing in on the tab and
pulling outward. See Figure 4-108.
Remove the 7
mounting screws.