2
SITE PREP TASKS
SELECTING THE SITE
Decide where to install the printer based on the following:
1. Space Requirements
2. Workstation Requirements
3. Environmental Requirements
4. Electrical Requirements
5. LAN Requirements
SPACE REQUIREMENTS
UNCRATED DIMENSIONS AND WEIGHTS
Make sure that the installation location can accommodate the printer’s weight and dimensions, plus required
clearances. The installation location must be a stable flat surface capable of holding 220 pounds (100 kg) for
single material bay option, and 260 pounds (120 kg) for additional material bay option.
MINIMUM CLEARANCES
Sufficient rear and side clearances allow for proper air circulation, while sufficient front clearance allows enough
room for the oven door to be opened. The installation location must have a height clearance of 36-40 inches
(90-100 cm) for single material bay option, and 46-50 inches (117-127 cm) for additional material bay option.
ENVIRONMENTAL REQUIREMENTS
•
The uPrint SE/uPrint SE Plus printers are for indoor use only.
•
Air quality conditions with excessive solid particulates (conductive or non-conductive) may
result in system damage.
•
Air quality conditions in which airborne oils are allowed to accumulate on or within the printer
can damage the plastic components.
Height
30 inches (76.2 cm)
Width
26 inches (66 cm)
Depth
26 inches (66 cm)
Weight
130 pounds (59 kg)
Material Bay Height
6 inches (15.2 cm)
Material Bay Width
26 inches (66 cm)
Material Bay Depth
26 inches (66 cm)
Material Bay Weight
17 pounds (7.7 kg)
Side Clearance
Minimum 6 inches (15.2 cm) on each side
Rear Clearance
Minimum 4.5 inches (11.4 cm)
Front Clearance
Minimum 17 inches (43.2 cm)
