Basic User Operations
Post-Print Procedures
Page 46
© Copyright 2022 Stratasys. All rights reserved.
Post-Print Curing
Place parts in the UV curing equipment and run until fully cured. The entire surface of the part
should receive light from the UV curing machine. The part may need to be rotated during the
cure process to ensure all sides are fully cured. A radiometer should be used to ensure the part
is receiving a full dosage according to the material TDS or Stratasys recommendation.
Figure 26: Curing parts
Each material requires a unique post-curing process. Detailed material post-
processing information for each Origin One certified resin can be found on the
Stratasys Support Center.