Basic User Operations
Post-Print Procedures
Page 43
© Copyright 2022 Stratasys. All rights reserved.
2. Place the build head with attached part(s) on a tray and carry it over to the part staging/
cleaning area.
Figure 22: Build head with parts
Detaching Printed Parts
1. Using a razor blade or small scraper, firmly and carefully scrape along the face of the build
head to remove the printed part(s). Increase pressure until the part separates from the build
Using a tray to transfer the build head to the cleaning area is not required, but will
prevent any uncured resin from dripping onto unwanted areas.