Overview
Network Configuration
Page 22
© Copyright 2022 Stratasys. All rights reserved.
Firewall Configuration
Each Origin printer acts as its own VPN endpoint on your end and connects to the Origin cloud
VPN gateway at
35.232.242.122:51820
.
Origin printers will use a UDP port in the range of
51000-51999
on your internal network. The
UDP port range is required so Network Address Translation (NAT) functionality in your firewall
can route inbound packets to the correct printer. At least one unique port must be allocated per
installed printer.
Origin printers will automatically send keep-alive packets to keep UDP connections open. On
the VPN port, printers will only accept authenticated packets from the gateway, and vice versa.
Additional Configuration
Origin printers use DHCP by default, but may be configured to static IP addresses on the
subnet of your choice. The printers use 10.144.0.0/16 internally for VPN communication.
DHCP must not assign addresses in the 10.144.0.0/16 subnet, otherwise address conflicts will
be created.
Locally, the printers may have SSH port 22 open, to support authorized onsite service by
Stratasys personnel.
Static IP Configuration
A static IP address can be used for your Origin One network configuration. To set up a static IP
address the following information is required:
• Static IP address
• Router prefix
• Gateway
Table 1: Firewall Configuration
Protocol
Source IPs
Source Ports
Destination IPs
Destination
Ports
UDP
<Printer Subnet Range>
51000-51999
35.232.242.122
51820
The
<Printer Subnet Range>
and internal
51000-51999
port range are default
configuration values. If you prefer a specific subnet or internal port range, we can
preload printers with a custom configuration.