Strata CIX 200, Programming Manual

Page: 21 / 508

Strata CIX Programming Vol.1 12/09
1-1
St
ra
ta
C
IX
Pr
og
ram
m
in
g
Strata CIX Programming Guidelines
1
This chapter discusses Strata CIX programming basics and guides you through initial setup procedures. It
also describes auto-recognition features, order of programming, and overview of general CIX Network
eManager, and Button Programming operations. Programming sequence tables are provided to streamline
your programming tasks.
Use Default Auto-programming to Start Up
Important! All programs and instructions apply to all Strata CIX100, CIX1200 and CIX670 systems,
unless specified otherwise.
The CIX40 has a default database already stored. Refer to the CIX40 Installation Manual
(CIX-IM-CIX40) for details.
This feature reduces the programming time to install Strata CIX systems. The Strata CIX system will
automatically program specific default data in a number of programs based on the PCBs that are installed
in the system before processor initialization. The default data and procedure for auto-programming is
provided in this section.
1. Install all line, station and optional PCBs that should be recognized for auto programming.
2. Power-on the system and initialize auto-programming for the system (Program 900, Level 1).
3. Verify ”Station and BIOU Auto-programming’ on page 1-2 .
4. Verify ”Station PDN Auto-programming’ on page 1-3 .
5. Verify ”CO Line Auto-programming’ on page 1-3 .
6. Verify ”CIX Processor NIC Interface TCP/IP Auto-programming’ on page 1-9 .
Note
•
The type of PCB, its cabinet and slot position are automatically recognized upon system initialization;
or, when powering the CIX processor for the first time.
•
Each installed PCB circuit equipment number is set in numerical order based on the cabinet and slot
position of the PCB.
•
Station Primary Directory Numbers (PDN) and CO line numbers are set in numerical order according
to their equipment cabinet/slot positions.
•
Other default data, such as the Strata CIX LAN and modem interface IP address, station and line class
of service, outgoing and incoming line groups, etc., are automatically set for the optional hardware
originally installed.