1
QUICK START GUIDE
65710
WWW. ST R A N D L I G H T I N G .CO M
VISION.NET GATEWAY
SERIES
65710
Vision.Net Gateway
65730
Vision.Net Interface Gateway Module
This document provides basic setup instructions and safety warnings for the following product(s):
INSTALLATION AND SETUP
POWER REQUIREMENTS
Vision.Net Gateway may be powered via either a Power over Ethernet (PoE) supply or from an external DC pow-
er supply connected via a set of screw terminals.
NOTE:
DC and PoE power connections will not operate as a redundant power solution.
A CR1225 backup battery (pre-installed) is used for the real-time clock. External modules are powered from the
Gateway module through the DIN rail bus system, and do not require their own power supply.
The Gateway draws up to 40W of power, depending on the confi guration of modules added. For PoE supplies it
is best to use an 803.2bt class7-8 high power source, however in some circumstances, it may be powered from
an 803.2af PoE+ supply. Consult the table below for further information to select the right options.
PoE REQUIREMENTS
COMBINATION
PoE PSE TYPE
DESCRIPTION
Gateway standalone
802.3af
12W @ the gateway
G 1 VN
802.3bt class 5 or higher
40W @ the gateway
MOUNTING / INSTALLATION
WARNING!
Do not power the system until all modules are placed and
connected as described in the steps below.
To mount Vision.Net Gateway and other modules:
Step 1.
Unpack module(s), taking precautions against ESD.
Step 2.
Place the DIN rail bus connector into the DIN rail.
Step 3.
Mount Vision.net Gateway module on DIN rail, taking care to ori-
ent the modules as shown. Take special care aligning, to prevent
bending the pins
•
If used, mount accessory modules close to Vision.Net Gate-
way module to ensure good contact
•
Place end-caps on the DIN rail bus to prevent
dirt contamination on the pins
Step 4.
If required, install DIN rail clamps (not supplied) as
necessary.
To remove modules from DIN rail:
Step 1.
Slide any modules apart
Step 2.
Insert fl at head screw driver against the tabs to
release. The DIN rail bus may; in some circum-
stances, remain attached to the rail and can be
removed by releasing the small clips, if required.
SERIAL
USB
WAN
LAN
−
24 VDC
2.7 A
+
PoE
VISION.NET GATEWAY
+
D
–
D
+
–
+
–
+
–
VISION.NET INTERFACE
GATEWAY MODULE
