
Electrical connection
Please refer to installation instructions for electrical connection.
In your own interest, and that of safety, make sure that the installation is carried
out by a competent person.
Disconnection of electric appliances should always be carried out by a competent
person.
Warning: This appliance must be earthed.
Step 1: Prepare installation
Do not lift the oven by the door handle.
Whilst every care is taken to eliminate burrs and raw edges from this product,
please take care when handling - we recommend the use of protective gloves
during installation.
Please note that the weight of this appliance is approximately
62kg
(unpacked).
Take care when lifting it into the housing unit - always use an appropriate method
of lifting.
If this appliance is to be installed near to a corner where the adjacent cabinets run
at right angles forward of the appliance, there must be a gap of at least 90mm
between the appliance and the cabinets, to prevent overheating of the cabinets.
1. Remove the fixing screws from the polythene bag on the top of the appliance,
but leave the appliance in the base tray packaging until you are ready to install
it.
Note: When removing the appliance from the base tray packaging care should
be taken to ensure the outer frame trim is not damaged.
2. (i) When installed in a typical 600mm deep
built in housing unit, the false back
should be removed from the housing
unit, to provide the necessary depth for
installation.
(ii) When the false back is removed, it is
normally the case that the support shelf
for the appliance leaves a gap between
the back edge and the wall of
approximately 80mm.
(iii) If no gap occurs between the back edge
of the shelf and the wall behind the unit,
we recommend that a gap of at least
30mm is made by shortening the shelf.
Installation
Rear wall
30 - 80
mm
Back edge of
support shelf
Front of
oven
12mm
gap in
plinth for
air intake
60
08 27317 02 - 900 Genus-AU:08 27317 01 -900 Gen 9/4/08 10:37 Page 62