Adjust the folds equally around the
Valve Collar making certain that the
Valve hangs straight down when the
Balloon is held at the end.
Bend the protruding end of the Bal-
loon back. Secure the Balloon by pull-
ing the Slipring over both the Valve
and the Balloon Fixation Ring so that
the Balloon Fixation Ring is no longer
visible and the protruding end of the
Balloon points backwards.
Align Valve Balloon to Valve
Valve Balloon ready to use
Fixing the Balloon with the Slipring
If needed, the extending collar can be
trimmed away using a pair of scissors,
making certain not to poke a hole into
the Balloon.
11. AT TACHMENT TO THE
EASY VALVE
WITH
BALLOON ADAPTER RESP.
SOLID VALVE
Balloon Sets may be ordered
from
www.storz-bickel.com
.
The Liquid Pad is used to vaporize the
extracts (aromatic oils) of the plants
specified in the plant list. The stainless
steel wire of the Liquid Pad serves as
the carrier of the extract, comparable
to the unvaporizable plant fibers in va-
porization plant material.
Caution! The extracts are
usually concentrates; there-
fore, a very small dosage is
sufficient. The vaporized concen-
trates may not be inhaled directly, but
instead pumping them into the room
air directly from the Filling Chamber
without the Valve Balloon attached.
12.1. Preparation
If the Liquid Pad is used, the Screens
in the Filling Chamber are not re-
quired and should be removed. This
applies to the Filling Chamber of the
EASY VALVE
as well as to the Filling
Chamber of the
SOLID VALVE
. In both
cases the Liquid Pad is inserted in
place of the lower Screen in the Fill-
ing Chamber. You will need the Filling
Chamber Disc of the Filling Chamber
Insert of the
SOLID VALVE
as this
Valve cannot open without the Filling
Chamber Disc.
12. LIQUID PAD
Preparation to use the Liquid Pad
12.2. Application
Turn the Filling Chamber upside down
and use a pipette to drop the extract
onto the center of the bottom of the
Liquid Pad. The Liquid Pad can hold
up to 10 drops. If you use an extract
with unknown concentration, use
maximum one drop and carefully in-
crease the amount until you achieve
the correct dosage.
Applying drops with a pipette
Please note that oils become
more liquid at high tempera-
tures. If you use too many
drops, the extract could drip into the
Hot Air Generator, which must be
avoided.
42
43
