StorageTek SL8500, User Manual

Page: 88 / 142

hwActivation
B-8 StorageTek SL8500 User's Guide
drive fastLoad {on | off | print}
Turns on or off or prints the status of the fastLoad feature. FastLoad changes the
behavior of drive mounts (move commands). With fastLoad on, the robot will not wait
for a complete load of a PUT to a drive, but will go immediately to the next operation.
Also changes the behavior of the rewindUnload command to return immediately, not
waiting for the drive to unload. The state of the fastLoad applies to all drives.
drive print { <drive address> | * }
Displays summary drive information: location, state, status, type, firmware version,
interface type, in use, serial number, state (online/offline), status (ok, warning, or
error), and drive vendor.
■
<drive address> - specifies the drive in library, rail, column, side, row format.
■
* - displays drive information for all drives in the library
drive search {on | off} <drive address>
Causes the green LED on the drive tray to blink. Blinking continues until the search off
command issued.Used to locate a drive within the library.
■
<drive address> - specifies the drive in library, rail, column, side, row format.
hwActivation
This command activating certain library features after purchasing a hardware
activation permit.
hwActivation
Displays help for the hwActivation command, same as "help hwActivation".
hwActivation addLicenseFile
Adds a license file. The license file must be named SL8500_license_config .dsf. The full
path name being /usr/local/ SL8500_license_config .dsf.
hwActivation deleteFile <index>
Deletes the specified installed feature file.
■
<index> - specifies file number to delete as specified in the library controller
hwActivation module database. See "hwActivation listFiles".
hwActivation listFiles
Lists the installed feature files in the library controller hwActivation module database.
hwActivation print
Lists all of the enabled features in the library controller hwActivation module
database.
Note:
This command only affects commands issued in the same CLI
session where this command was issued.
Note:
The library must be rebooted when disabling openVolser,
dualRobot, partitioning, or redundant electronics.