StorageTek L180, Service Manual

Page: 64 / 266

Configuration Overview
2-20 Fifth Edition 95897
Setting the Network Gateway Address
Note: Entering this address is optional. It serves to indicate the gateway
connection between subnets, but it is applicable only when such a
connection exists and is necessary to library operation.
Consult the systems administrator for additional information.
To set the network gateway address:
1. At the Network Config Menu, press an arrow button until the cursor
underscores
NETWORK GATEWAY.
2. Press the
SELECT
button. An editing screen appears.
3. On the editing screen:
a. Use the up and down arrow buttons to select a value for each digit
(field) in the address.
b. Use the
SELECT
button to move right to the next field.
c. Use the
MENU
button to move left to the previous field.
4. When the screen displays your desired setting, press the
SELECT
button
from the right-most field to save the changes. Press the
MENU
button to
abort.
Setting the Subnet Mask Address
The system administrator might assign the library a subnet mask address if one
is required. This address makes the library accessible through a subnet on a
large network.
To set the subnet mask address:
1. At the Network Config Menu, press an arrow button until the cursor
underscores
SUBNET MASK.
2. Press the
SELECT
button. An editing screen appears.
3. On the editing screen:
a. Use the up and down arrow buttons to select a value for each digit
(field) in the address.
b. Use the
SELECT
button to move right to the next field.
c. Use the
MENU
button to move left to the previous field.
4. When the screen displays your desired setting, press the
SELECT
button
from the right-most field to save the changes. Press the
MENU
button to
abort.