StorageTek L180, Service Manual

Page: 134 / 266

MPC Card
4-44 Fifth Edition 95897
Replacement
CAUTION:
Possible ESD damage: Follow the ESD precautions outlined in
“Electrostatic
Discharge Damage Prevention” on page xxiii .
1. Remove the MPC card from the anti-static bag.
2. Make sure the SCSI jumpers on the new card are set in the same position as those on the
old card.
CAUTION:
Possible equipment damage: Be careful not to damage the cables when you install
the card.
3. Tilt the right side of the card into the slot to clear the cables on the left side, then push
the left side of the card back and insert the differential SCSI connector into the rear slot.
CAUTION:
Possible equipment damage: Make sure the screws do not fall into the fan assembly.
4. Hold the card while you install the three standoffs.
5. Install the 14 screws into the card.
Note: Do not overtighten the standoffs or screws.
1. Screw (14)
2. Standoff (3)
E67155
2 1