22
Roof Cover Installation
NOTE: DO NOT install the cover onto the frame of your building in high wind conditions. A slight breeze
is the most advantageous for cover installation. To take advantage of the breeze, pull the cover up over
the arches with the breeze blowing in the cover like a sail filled with air.
1. Roll out the roof cover on a ground sheet. Align the cover evenly to each end of the frame. Be sure
doing not over pull the end of roof cover.
2. Pull the roof cover over frame EVENLY, CAREFULLY AND SLOWLY. Insert tensioning tube (No.9) into
the pipe pockets. Cut a small opening over against every base plate. Put the belt (No.14) around
tensioning tube and go through ratchet on base plate and loosely secure. DO NOT TIGHTEN. Adjust
the cover so that it is square and evenly centered on the frame.
Note: The end flaps must overhang evenly at both ends.
3. Use Knitting Rope (No.15) to tighten roof cover to end arches.
4. When roof cover is tidy and ready, drive the ratchet tie down forth and back and then roof cover is
tightened in the vertical direction.
5. Tidy the cover. Pull the strap inside the end of roof cover, make the cover well fold to end arches
and fasten the strap with ratchet.
Summary of Contents for FB204016DP
Page 20: ...20 Front Cover Installation...
