STONEX SC400A, User Manual

Page: 23 / 49

October 2021 – Ver. 1 Stonex SC400A CORS Receiver – User Manual 23
4.3 NTRIP Server
Command for data transmission configuration with NTRIP protocol. This command does not have submenus. On the only
page available in this section, you can set the transmission content and the server for the SC400A reference station. The
password on this page can be entered arbitrarily but the field cannot be left blank. When [Auto Connect] is chosen, after
the network is disconnected, the data transmission will be connected automatically, otherwise the transmission will have
to be started manually. Before setting the parameters, go back to the reference station page and make sure the base station
coordinates are correct. If you need to start with known coordinates, enter the known coordinates. After setting the
parameters. In the status bar, you can see the status of the data transfer displayed.
If the data must be transmitted to an external caster: address, port and password are those of the external caster.
If SC400A is to act as a caster: NTRIP caster function must be enabled (see Port Configuration page) address is 127.0.0.1,
port must be the same as that indicated on the NTRIP caster function (see Port Configuration page).
Phase center: if enabled, the transmitted coordinates are correct for the offset of the phase center. Otherwise, the
coordinates defined on the Reference Station page are transmitted.