V8.0.3x
©StoneFly Inc. 2019 | All rights reserved
Page 13
StoneFly DR365V-3605 Getting Started Guide
Initial Installation
2.2.
Power Up & Initial Access
These are the steps a user needs to follow in order to start using the StoneFly DR365V
Hyperconverged Appliance:
1-
Connect both power supply modules to a power outlet using the included power cords.
2-
Connect Ethernet cables to the System Management, Network (iSCSI/NAS), and IPMI
ports as shown in the diagram below:
Back Panel Connections of the DR365V-3605
3-
If you purchased the appliance with additional network ports, then please connect those
as well.
4-
Connect a monitor to the VGA port.
5-
Connect a keyboard and a mouse to the USB ports.
6-
Power up any Expansion Units, then power up the DR365V appliance.
NOTE:
•
Serial port is not used by the DR365V appliance.
•
SAS Expansion port is only used when connecting StoneFly Expansion Units to
the DR365V Appliance for additional storage capacity.
•
Do not connect an Ethernet cable to the RAID port.
•
There are different configurations for network ports. Make sure to follow the
labeling on your system when connecting the Ethernet cables.
USB Ports
Data Ports
IPMI
RAID Management Port
(Do
NOT
connect)
Power
Supply
VGA Ports
Management Ports
SAS Extension
