V8.0.3x
©StoneFly Inc. 2019 | All rights reserved
Page 13
StoneFly DR365V-2404 Getting Started Guide
Initial Installation
2.2.
Power Up & Initial Access
These are the steps a user needs to follow in order to start using the StoneFly DR365V
Hyperconverged Appliance:
1-
Connect both power supply modules to a power outlet using the included power cords.
2-
Connect Ethernet cables to the System Management, Network (iSCSI/NAS), and IPMI
ports as shown in the diagram below:
Back Panel Connections of the DR365V
3-
If you purchased the appliance with additional network ports, then please connect those
as well.
4-
Connect a monitor to the VGA port.
5-
Connect a keyboard and a mouse to the USB ports.
6-
Power up any Expansion Units, then power up the DR365V appliance.
NOTE:
•
Serial port is not used by the DR365V appliance.
•
SAS Expansion port is only used when connecting StoneFly Expansion Units to
the DR365V Appliance for additional storage capacity.
•
Do not connect an Ethernet cable to the RAID port.
•
There are different configurations for network ports. Make sure to follow the
labeling on your system when connecting the Ethernet cables.
USB Ports
Data Ports
SFP+ Data
IPMI
RAID Management Port
(Do
NOT
connect)
Power Supply
VGA Ports
Management Ports
SAS Extension
