Stoll CMS ADF-3, Operating Instructions Manual, Page: 310 / 444

Repairing the knitting machine
7
Replacing parts 7.3
310
7.3.4 Replacing holding-down jack
1. Transfer all stitches of the needle bed in which the jack is replaced to
the other needle bed.

Removing the limiter (3)
2. Remove screw (1) on left and right-hand sides of jack bed. Use the
special hexagon screwdriver from the accessories for this purpose.
3. Loosen the screw (2) on the left and right-hand sides of the jack bed.
4. Remove the limiter (3) on both sides.

Replacing a jack
5. Pull out wire (4) and, with gauges E3,5.2, E5.2, E6.2, E7.2, E9.2 (with
72") wire (6) as well, up to the point of repair. When doing so, always
guide in the replacement wire from the accessories after it from the
other side of the machine so that the jacks do not fall out of the needle
bed.
6. Pull out the wire (5).
7. Take out the holding-down jack from above and insert a new one.
8. Reassemble the needle bed in the reverse order.
Further information:

Helpful knitting rows [-> 303]