Stocks AG Fan Jet Duo, General Installation And Operation Instructions

Page: 12 / 31

Fan Jet Pro - Operating Manual & Parts List P12
Safe lifting practice to be observed when handling the machine as the net weight is over 25kg.
Safety shoes and protective gloves to be worn when handling the machine.
With a full hopper the 65L machine could weigh in excess of 80kg and the 130L machine 135kg and so ensure
the machine is securely attached to a suitably strong rigid mounting point.
If unsure seek advise from the parent machine manufacturer or supplier.
Locally fabricated mounting frames are not the responsibility of Stocks AG Ltd.
NOTE: the machines can be operated facing forwards or backwards.
Ensure the disc height is a minimum of 1 metre above the crop canopy or the ground – more height may
improve the maximum spread width.
Ensure the power cable is connected direct to the parent vehicle 12v battery and the fuse is fitted correctly.
Always adhere to Health and Safety guidelines when mounting or fabricating an
appropriate mounting frame and always wear suitable protective clothing
.
WARNING
the control panel is not waterproof and so will need to be protected
.
The cost option UTV kit available for most UTV
fitments. Offering a sturdy fitting option with 4 hooked
anchor points with hand release fittings. One piece
tubular steel construction with
detachable machine mounting plate. Fixed fork lift
point safe and easy lifting on and off vehicle.
WARNING
Always check specification of any ATV rear carrier before ordering
8.0 Installation Guide
8.1 ATV Fitting Kit - Optional
The Stocks ATV Kit provides a quick and easy way to
attach your Fan Jet to the rear carrier of your ATV.
Designed as a universal fitment to elevate the Fan
Jet to gain more height to the spinning disc. The
formed steel base plate with quick fit clamps and
jacking screws to mount the machine to the base
plate and to adjust the angle of the disc when the
ATV is fully laden.
The kit includes an operator protection plate which
bolts onto the back frame of the machine plus a
short power and connector cable to maximise the
power at the disc motor.
These are to be fitted rather than the standard
length cables supplied with the Fan Jet
machine.
Many rear carriers will not have the load
carrying capacity to support the weight of a fully
laden Fan Jet mounted on an ATV kit. Please
check with your ATV supplier as modification
may be available.
8.2 UTV Fitting Kit - Optional
Part No. FJ - 005 - UTV (available through your local dealer)
ATV fitting Kit available; Part No. FJ - 005 - BKT (available through your local dealer)