background image

SPXULED

The rubber mounting pads allow the lights to 

be mounted on a flat surface or a curved 

surface like a roll bar or tubalar frame. The 

lights can also be mounted flat, without the 

rubber mounting pad.

Once you have choosen a mounting loca-

tion, decide how the cable will be routed. For 

example, when mounting on a roll bar, is the 

cable going to be routed inside the tube or 

on the outside. The rubber mounting pads 

allow you to route the cable outside, without 

drilling a hole for the cable (FIG B).

Using the template below, mark and drill the 

mounting holes. If you are running the cable 

through the mounting surface (FIG A & D), 

you will also need to drill a 1/4” hole for the 

cable.  Use the center hole when mounting 

with the rubber mounting pads. Use the offset 

hole if mounting the light only, no mounting 

pad.

UNIVERSAL LED UNDER-BODY/DOME 

WHAT’S INCLUDED

2 x CREE LED Pods

2 x Rubber Mounting Pads 

4 x Mounting Hardware

Before you start, review directions completely. 

If your vehicle is not pre-wired for external lighting, 

you may need the following:

Inline Fuse Holder (SPXATC16 or similiar) 

3 Amp Fuse

Switch

Relay

2 Strand Primary Wire

Wire Connectors / Solder

Wire Cover

Zip-Ties

Center Cable Hole

Offset Cable Hole

Mounting Hole

Mounting Hole

FIG A

Flat surface with mounting pad and cable going 

through mounting surface

FIG B

Curved surface with mounting pad and cable routed

out the mounting pad. 

MOUNTING THE LED PODS

FIG C

When running the cable through the mounting pad holes,

you will need to cut a slit in the rubber 

Cut Line

FIG D

Flat surface without using the mounting pad. Cable will need to go

through the mounting surface. 

Reviews: