State: 30.06.2021 p. 7
Mounting instructions for multiplay „angulus 5“
Item-No. 51 7525 601
© stilum GmbH, Gewerbegebiet Larsheck, D-56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modifications reserved.
18. Cover the entire impact area with fall protection according to the required
drop height in accordance with EN 1176-1.
Critical drop height: 1750 mm.
Recommended surface material: sand, wood chip, gravel, synth. impact
protection.
With a smaller installation depth (special edition) we recommend synthe-
tic impact protection. In this case, make sure that protruding parts (e.g.
screws, gusset plates) are covered with appropriate fall protection.
19. Do not allow children to use the equipment before the installation has
been finished.
Attention:
If the play equipment has been incompletely installed or partly
dismantled when carrying out maintenance and repair work, this may lead to
particular risks of injury for the user. For this reason, make clearly visible that
the equipment shall not be used in such cases.
STAINLESS STEEL
NOTE:
Play equipment, which contain components made of stainless steel
should not come with „normal“ steel parts in contact. Those steel parts may
rub off and leave small steel particles in combination with moisture brown rust
stains.
MAINTENANCE:
If such corrosion occur on stainless steel parts, they are
fine to remove with an abrasive (240 grit).
Please take care when transporting and setting up the fact that the compo-
nents are made of stainless steel with no „normal“ steel parts in contact.
In order to preserve a good visual appearance of your stilum playground equip-
ment over a long period one should take care of maintenance of the stainless
surface even despite of their corrosion resistance.
Especially areas, which can not be reached by rainfall should be frequently
cleaned from dirt and deposits due to air pollution and dirt caused by the
atmosphere.
Light soiling can easily be romoved by using a high pressure cleaner.
For persistent deposits use a clean cloth moistened with a special liquid cleaner
(e.g. on phosphoric acid) and rinse off with clear water after a short application time.
During cleaning with mild abrasive components, only wipe over stainless steel sur-
face in polishing direction.
For heavily soiled surfaces, polishes can be used (e.g. for cleaning chrome on cars)
or for greasy and oily dirt alcoholic cleaning agents and solvents (e.g. ethyl alcohol,
isopropyl alcohol or acetone).
However, it should be noted that the dissolved soiling is not spread over the surface
again.
Do not use any chlorid or hydrochloric containing cleaning products nor scouring
powder, bleaching - or silver polish cleaner. Cleaning intervals depend on type and
degree of soiling as well as on demands made on optical characteristics. Therefore
cleaning is advisable at intervals of six to twelve months – whereby in the case of
strong soiling it is appropriate to clean the playground equipment at intervals of three
to six months.
WOOD
NOTE:
For all play equipment with wooden elements, it cannot be ruled out that dry
cracks may develop. These natural changes of wood are dependent on climate con-
ditions as well as on the age and usage of the play equipment. Longer dry periods
may lead to more dry cracks.
This development, however, does not represent a quality defect. Static properties of
the equipment are not impaired.
See EN 1176 Bbl 1:2019-01 4.2.7.6: Dry cracks in wood elements as a consequence
of weather conditions are not to be considered as dangerous openings in terms
of the standard due to the fact that the shape of the cracks (tapering towards the
inside) makes it almost impossible for fingers to get trapped in them.
