Still SXH-20, Original Instructions Manual

Page: 27 / 126

Residual dangers, residual risks
Despite all operational precautions and com-
pliance with standards and rules, the possibili-
ty of additional risks when using the truck can-
not be entirely excluded.
The truck and all its components comply with
the regulations relating to current applicable
safety rules.
Persons in the vicinity of the truck must be
particularly cautious and react immediately in
the event of any malfunction, incident, break-
down etc.
WARNING
Personnel in contact with the truck must be informed
of the risks related to using the truck.
These operating instructions draw your attention to
the safety rules.
The risks are:
●
Escape of consumables due to leaks, rup-
tured lines and tanks etc.
●
Risk of accident when driving over difficult
ground such as slopes, soft or irregular sur-
faces or in poor visibility etc.
●
Falling, tripping etc. when moving on the in-
dustrial truck, especially in the wet, with
leaking consumables or icy surfaces.
●
Loss of stability due to the load being unsta-
ble or the load slipping etc.
●
Risk of fire and explosion due to batteries
and electrical voltages.
●
Human error - Disregarding safety regula-
tions.
It is important to adjust the speed of the truck
depending on the load and ground conditions.
The stability of the truck has been tested to
the latest standards. These standards only
take account of the static and dynamic tilting
forces that can arise during operation that
complies with the specifications and operating
rules. Risks caused by misuse or incorrect op-
eration that jeopardise the stability cannot be
ruled out in extreme situations.
Stability
Stability is only guaranteed if the industrial
truck is used according to the indicated rec-
ommendations.
It is not guaranteed in the event of:
–
cornering at high speeds
–
moving with a load that is protruding to the
side (e.g. sideshift)
–
turning and driving diagonally on descents
or ascents
–
driving on descents or ascents with the load
on the downhill side
–
loads that are too wide or too heavy
–
driving with an unstable load
–
ramp edges or steps.
Safety
2
Residual dangers, residual risks
17 11548011551 EN - 02/2021 - 07