5
Maintenance
Safety regulations for maintenance
Safety regulations for maintenance
General information
DANGER
Risk of fatal poisoning!
It is dangerous to leave the engine running in
enclosed spaces. The engine consumes oxygen
and emits carbon dioxide, carbon monoxide and
other poisonous gases. There is a risk of fatal
poisoning!
– Only operate the truck in areas that are well
ventilated.
To prevent accidents during maintenance
work and repair work, all necessary safety
measures must be taken, e.g.:
– Apply the parking brake.
– Switch off the key switch and remove the
key.
– Ensure that the truck cannot move uninten-
tionally or start up inadvertently.
– If required, have the truck jacked up by the
authorised service centre.
– Have the raised fork carriage or the ex-
tended lift mast secured against accidental
lowering by the authorised service centre.
– Insert an appropriately sized wooden beam
as an abutment between the lift mast and
the cab, and secure the lift mast to prevent
it tilting backwards unintentionally.
– Observe the maximum lift height of the lift
mast, and compare the dimensions from
the technical data with the dimensions of
the hall into which the truck is to be driven.
These steps are taken to prevent a collision
with the ceiling of the hall and to avoid any
damage caused as a result.
Working on the hydraulic equipment
The hydraulic system must be depressurised
prior to all work on the system.
310
57348011800 EN - 11/2018
Summary of Contents for RX70 Series
