Still RX70 Series, Original Instructions Manual

Page: 137 / 406

Operation
4
Driving
Roadways
Dimensions of roadways and aisle widths
The following dimensions and aisle width
requirements apply under the specified
conditions to ensure safe manoeuvring. In
each case, it must be checked whether a
larger aisle width is necessary, e.g. in the
case of different load dimensions.
Within the EU, the 89/654/EEC directive
(minimum health and safety requirements
for the workplace) must be observed. The
respective national guidelines apply for areas
outside of the EU.
The required aisle widths depend on the
dimensions of the load.
For pallets, these are:
Aisle width [mm]
Model
Type
with pallet
1000 x 1200
crosswise
with pallet
800 x 1200
lengthwise
RX70-60 7341 4907 5107
RX70-70 7342 4987 5187
RX70-80 7343 5056 5256
RX70-80
(LSP 900)
7344 5185 5385
The truck may only be used on roadways
that do not have excessively sharp bends,
excessively steep gradients or excessively
narrow or low entrances.
Driving on gradients
WARNING
Driving up and down longer gradients may cause
the drive unit to overheat and switch off.
Driving up and down long gradients steeper than
15% is not permitted due to the minimum specified
braking values. The climbing capability values
given below only apply to overcoming obstacles on
the roadway and to short differences in level, e.g.
ramps.
The truck may be driven on the following
upwards or downwards gradients:
57348011800 EN - 11/2018 125