Still RX70-16, Original Instructions Manual

Page: 160 / 380

4
Operation
Lifting
Possible restrictions on the "lift mast
vertical position"
In some circumstances, the lift mast cannot
move exactly into the preset vertical position.
Possible causes include:
• Uneven ground
• Bent fork
• Bent attachment
• Worn tyres
• Severely deformed lift mast
The vertical position can be corrected by tilting
the lift mast using the relevant operating
device. If the vertical position has to be
corrected frequently, the "lift mast vertical
position" should be calibrated.
6210_003-070_en_V2
1 2
3
Calibrating the "lift mast vertical position"
– Set the lift mast to the required position.
– Press and hold the button (1) for the "lift
mast vertical position" for at least five
seconds.
The message "
? VERTICAL POSITION
"
will appear on the display.
Storing the mast position:
– Press the drive program selector button (3).
The current mast position is stored.
Cancelling calibration:
– Press the menu change button (2).
The calibration is cancelled.
Types of lift mast
One of the following lift masts may be installed
in the truck:
148 174749 EN - 03/2017