Still RX60-60, Original Instructions Manual

Page: 368 / 408

–
The belt tongue (2) must release when the
red button (4) is pressed.
–
The automatic blocking mechanism must be
tested at least once a year:
–
Park the forklift truck on level ground.
–
Pull out the belt with a jerk.
The automatic blocking mechanism must
block extension of the belt.
–
Tilt the seat at least 30 ° (if necessary, re-
move the seat).
–
Slowly extend the belt.
The automatic blocking mechanism must
block extension of the belt.
Cleaning the seat belt
–
Clean the seat belt as necessary, but with-
out using chemical cleaning materials (a
brush will suffice).
Replacement after an accident
As a rule, the seat belt must be changed after
an accident.
Checking the driver's seat
WARNING
Risk of injury!
–
After an accident, check the driver's seat with at-
tached restraining belt and fastening.
–
Check the controls for correct operation.
–
Check the condition of the seat (e.g. wear
on the upholstery) and secure fastening to
the hood.
WARNING
Risk of injury!
–
Have the seat repaired by the service centre if you
identify any damage during the checks.
7090_342-005
1
4

6327_342-010

Maintenance
5
Preserving operational readiness
356 56358042501 EN - - 11