Still RX60-35/600, Original Instructions Manual

Page: 193 / 470

Operation
4
Lifting
Overriding and reactivating the auto-
matic lift cut out
If a load needs to be lifted to the truck's
maximum lift height and the automatic lift
cut out function is not required, it is possible
to override the lift cut out. It is automatically
reactivated when the truck is switched off and
back on again.
To override the automatic lift cut out:
F1
1
7312_003-160_V3
– Press Softkey (1).
Automatic lift cut out is switched off.
The symbol is displayed. Loads can be
lifted to the maximum lift height for the truck.
To switch the automatic lift cut out back on:
– Press Softkey
(1).
Automatic lift cut out is switched on.
The symbol is displayed. Loads can be
lifted only to the set lift height for the truck.
Lift mast vertical position (variant)
Description
If the truck is equipped with the "lift mast
vertical position" comfort feature (variant),
the driver can put down goods, such as paper
rolls, vertically with precision and thus avoid
damage when unloading. The tilt cylinders
run into the end stops gently to prevent hard
vibrations and impacts. Oscillating motions of
the truck are minimised, thus increasing work
safety. The lift mast vertical position reduces
wear on various components and therefore
reduces maintenance costs.
171533 EN - 02/2019 - 19 179