Still RX60-35/600, Original Instructions Manual

Page: 192 / 470

4
Operation
Lifting
Releasing the block on the hydraulics
Proceed as follows to release the block on the
hydraulics:
– Sit down on the driver's seat.
All the relevant functions of the working
hydraulics will be available again.
NOTE
If it is not possible to release the block on the
hydraulics when the load is raised because
of a technical fault, the load must be lowered
using the "emergency lowering" mechanism
before any further action is taken. Do not
operate the truck again until the fault has been
rectified by the authorised service centre.
Automatic lift cut out (variant)
Description:
The automatic lift cut out (variant) means that
the load cannot be lifted above a preset height.
This function uses a sensor that is welded on
at the factory at the required lift mast limit
height. Once attached, the height cannot be
easily changed.
Application:
• If the ceiling of the building is lower than
the maximum lift height of the truck, this
variant can prevent the lift mast from
accidentally hitting the ceiling, which can
result in damage.
• If the truck is frequently used at a particular
height, the work is simplified by the auto-
matic lift cut out at this height.
NOTE
If a load is lifted very quickly, the fork carriage
and load are moved approximately 15 cm
above the position of the sensor due to
inertia. This deviation is already taken into
consideration at the factory when determining
the position of the sensor.
178 171533 EN - 02/2019 - 19