Still RX60-35/600, Original Instructions Manual

Page: 158 / 470

4
Operation
Driving
6210_00 3 -050_V4
2 1
Actuate the electric parking brake
The electric parking brake is intended for
working cycles that require the driver to leave
the truck frequently. The parking brake does
not need to be applied or released manually.
Despite these automatic aids, the driver
is always responsible for parking the truck
safely. The safety information about parking
the truck safely applies.
DANGER
There is a risk of fatal injury from being run over if
the truck rolls away.
– Do not park the truck on gradients.
– Use wedges to secure the truck on the downhill-
facing side.
– Only leave the truck when the parking brake is
applied.
NOTE
The electric parking brake can be activated or
released only if the battery male connector has
been connected and the key switch is switched
on. The LED(2.) lights up as soon as the truck
is switched on. Only the display-operating unit
indicates that the parking brake is applied.
– Stop the truck.
As soon as the driver leaves the seat, the seat
switch is released and the parking brake is
applied. The LED (2) in the push button for the
parking brake lights up continuously.
The electric parking brake is applied automat-
ically in the following situations:
Cause Effect
When the driver leaves the driver's seat:
After a short waiting period, you will hear
the parking brake engage and the LED (2)
illuminates with a steady light.
When the driver takes his foot off the accelerator
pedal:
After a short waiting period, you will hear
the parking brake engage and the LED (2)
illuminates with a steady light. The truck is
held by the traction motor on a gradient until
the parking brake is applied.
144 171533 EN - 02/2019 - 19