Still RX60 35-50, Original Instructions Manual

Page: 550 / 596

Check the hydraulic oil level
WARNING
Hydraulic oils are hazardous to your health.
–
Observe the safety regulations set out in the sec-
tion entitled "Hydraulic fluid".
NOTE
When changing to a different type of hydraulic
oil, the authorised service centre must adjust
the parameters of the truck control unit.
–
Park the truck securely on a horizontal sur-
face.
–
Tilt the lift mast backwards until it reaches
the stop.
–
Lower the fork carriage; if attachments are
fitted, retract the working cylinders.
CAUTION
Potential for damage to the battery male connector!
If the battery male connector is disconnected while
the key switch is on (under load), an arc will be
produced. This can lead to erosion at the contacts,
which considerably shortens the service life of the
contacts.
–
Switch off the key switch before disconnecting the
battery male connector.
–
Do not disconnect the battery male connector
while the key switch is switched on, except in an
emergency.
–
Disconnect the battery male connector.
–
Fold up the floor mat.
–
Turn the bayonet catches on the bottom
plate 90° to the left.
–
Fold up the bottom plate with the floor mat
and secure it in place.
–
Unscrew the breather filter with the dipstick
in an anti-clockwise direction.
–
Keep the breather filter and dipstick in a
horizontal position.
–
Check the oil level on the dipstick.
90
°
90
°

Maintenance
5
Preserving operational readiness
534 56388011501 EN - 05/2022 - 08