Still RX60 35-50, Original Instructions Manual

Page: 521 / 596

Rings, metal bracelets etc. must be removed
before working on electric components.
To prevent damage to electronic systems with
electronic components, such as an electronic
driving regulator or lift control, these compo-
nents must be removed from the truck prior to
the start of electric welding.
Work on the electrical system (e.g. connecting
a radio, additional headlights etc.) is only per-
mitted with approval from the authorised serv-
ice centre.
Safety devices
After maintenance and repair work, all safety
devices must be reinstalled and tested for op-
erational reliability.
Set values
The device-dependent set values must be
observed when making repairs and when
changing hydraulic and electrical components.
These are listed in the appropriate sections.
Lifting and jacking up
DANGER
There is a risk to life if the truck tips over!
If not raised and jacked up properly, the truck may
tip over and fall off. Only the hoists specified in the
workshop manual for this truck are allowed and are
tested for the necessary safety and load capacity.
–
Only have the truck raised and jacked up by the
authorised service centre.
–
Only jack the truck up at the points specified in the
workshop manual.
The truck must be raised and jacked up for
various types of maintenance work. The au-
thorised service centre must be informed that
this is to take place. Safe handling of the truck
and the corresponding hoists is described in
the truck's workshop manual.
Maintenance
5
Safety regulations for maintenance
505 56388011501 EN - 05/2022 - 08