Still RX60 35-50, Original Instructions Manual

Page: 337 / 596

The return flow is displayed in addition to the
supply flow at full brightness.
To adjust the revolution speed, press the
or softkey.
–
To save the setting, press the softkey.
The settings are saved.
–
To cancel the setting, press the softkey.
The settings return to the most recently set
value.
Clamp locking mechanism (var-
iant)
This truck can be fitted with a clamp lock-
ing mechanism for clamping attachments. The
clamp locking mechanism prevents the clamp
from opening unintentionally if the operating
function is inadvertently triggered.
DANGER
If the correct function of the clamp locking mecha-
nism is not guaranteed, there is a risk to life from a
falling load!
If other attachments in addition to the clamp are used
on this truck, the clamp locking mechanism must be
reassigned to the corresponding operating device ev-
ery time the clamp is reassembled.
–
Make sure that the authorised service centre reas-
signs the function of the clamp locking mechanism
to the corresponding operating device.
–
Make sure that the additional clamp locking mech-
anism function is available.
–
Observe the section entitled "Fitting attachments".
NOTE
For technical reasons, clamping attachments
must not be controlled via the "5th function".
The sections entitled "Controlling attachments
using ..." describe how the clamp locking
mechanism is operated.
Fleet manager
Forwards
Auxiliary hydraulics 2
3 900 1/min
54,6 L/min
Backwards 3 300 1/min
46,2 L/min
6219_003-28 4 _en

Operating
4
Attachments
321 56388011501 EN - 05/2022 - 08