Still RX60 35-50, Original Instructions Manual

Page: 201 / 596

Malfunctions in the electric park-
ing brake
DANGER
There is a risk of fatal injury from being
run over if the truck rolls away.
–
Do not park the truck on a gradient.
–
Do not leave the truck until the park-
ing brake has been applied.
–
In an emergency, secure the truck
with wedges on the downhill-facing
side to prevent it from rolling away.
–
Before leaving the truck, make sure that the
parking brake is properly applied.
Message:
Apply parking brake via button.
If the truck control unit detects a malfunction in
the parking brake, the truck cannot be switch-
ed off.
●
The
Apply parking brake via
button
message appears on the display-
operating unit.
●
The LED (1) on the push button (2) flashes.
●
A warning signal sounds.
NOTE
If it becomes necessary to switch off a truck
with a faulty parking brake, always secure the
truck to prevent it from rolling.
A possible cause of the malfunction is that
the parking brake cannot determine whether
the truck is stationary or still in motion. The
following section describes how to actuate the
parking brake when it is faulty:
Actuating a faulty parking brake when the
truck is stationary
There are two ways to apply the parking
brake:
–
Press and hold the push button (1) for at
least five seconds and then release the
push button.
or
6219_003-006_V2

Operating
4
Driving
185 56388011501 EN - 05/2022 - 08