Still RX60 35-50, Original Instructions Manual

Page: 195 / 596

DANGER
Risk of accident due to brake failure!
The regenerative brake only functions if the truck is
switched on, the emergency off switch has not been
actuated and the parking brake is released.
–
Use the brake pedal if the regenerative brake mal-
functions.
–
Engage the parking brake before leaving the
truck.
Changing the drive direction
–
Remove your foot from the actuated accel-
erator pedal.
–
Press down the accelerator pedal for the
opposite direction.
The truck travels in the selected drive direc-
tion.
NOTE
If an electrical fault occurs in the accelerator,
the drive unit is switched off. In this situation,
the truck is not electrically braked. Once the
electrical fault has been corrected, it will be
possible to drive the truck again by releasing
the accelerator pedal and then actuating the
accelerator pedal again. If the truck still cannot
be operated, park the truck securely and con-
tact the authorised service centre.
Operating the service brake
The regenerative brake converts the accelera-
tion energy of the truck into electrical energy.
When the accelerator pedal is released, the
truck decelerates.
–
To do this, release the accelerator ped-
al (1).
–
If the braking effect is inadequate, use the
brake pedal (2) in addition to the service
brake.
In the first section of the brake pedal's travel,
only the regenerative braking takes effect. As
the pedal is depressed further, the mechanical
brake is also activated and acts on the drive
wheels.
1
2
5060_003-006

Operating
4
Driving
179 56388011501 EN - 05/2022 - 08