Still RX60-25, Original Instructions Manual, Page: 329 / 470

Operation
4
Handling the lead-acid battery
6321_003-101_V3
3
– Disconnect the battery male connector (3)
from the truck.
DANGER
Explosive gases are generated during
charging.
– Ensure that work areas are
adequately ventilated.
– For trucks with a cab (including
fabric-covered cabs), ensure
adequate ventilation in the cab
(variant).
DANGER
There is a risk of damage, short circuiting and
explosions!
– Do not place any metal objects or tools on the
battery.
– Keep away from open flames and do not smoke.
WARNING
The electrolyte (diluted sulphuric acid) is poisonous
and corrosive!
– Observe safety regulations for handling battery
acid; see the chapter entitled "Battery acid".
– Rinse away spilt battery acid immediately using
plenty of water!
– Before charging, check the battery cable
and the charging cable for damage, and
have the cables replaced by the authorised
service centre if necessary.
CAUTION
Damage to the connection assembly is possible!
If the charging cable is connected while the battery
charger is switched on (under load), a transition
spark will be produced. This transition spark can
damage the contacts and considerably shorten the
service life of the contacts.
– Switch off the battery charger before you connect
the charging cable.
– Ensure that the battery male connector (3)
and the plug for the battery charger (4) are
dry, clean and free of foreign objects.
56338011803 EN - 02/2019 - 09 315
www. duma -rent.com