Still RX60-25, Original Instructions Manual, Page: 299 / 470

Operation
4
Display messages
? VERTICAL POSITION
If the message
? VERTICAL POSITION
appears on the display, calibration of the
"vertical lift mast position" has been activated.
– Save the mast position or cancel the
calibration.
7312_003-072_en_V3
REFERENCE CYCLE message
If the fork was lowered after the truck was
switched off, the control electronics do not
know the position of the fork when the truck
is restarted. The truck will only travel at a
reduced driving speed. Depending on the
position of the fork, the message
REFERENCE
CYCLE
(variant) may appear in the display. To
align the position with the control electronics,
the fork must be raised.
– Switch on the key switch.
The truck will only travel at a reduced driving
speed. The message
REFERENCE CYCLE
may appear in the display.
– Raise the fork.
The message
REFERENCE CYCLE
goes out,
or now appears in the display for the first time
and then goes out.
– To drive again, lower the fork to a maximum
of 300 mm above the ground.
The truck can now be driven again with no
speed limitation.
56338011803 EN - 02/2019 - 09 285
www. duma -rent.com