Still RX60-25, Original Instructions Manual, Page: 261 / 470

Operation
4
Auxiliary equipment
accelerator briefly and then operate the
accelerator again.
• Switching on the truck in a hall
If the truck is switched on inside a hall, the
ceiling detector system detects the hall
ceiling and reduces the driving speed to the
maximum speed that is set for halls.
Possible limitations for object recognition
• If the truck moves under larger overhead
structures outdoors, e.g. a pedestrian
bridge, the ceiling sensor system may
interpret this overhead structure to be a hall
ceiling and reduce the maximum speed.
• In rare cases, it may occur that the ceiling
sensor system does not recognize a ceiling
and does not then reduce the speed. This
can happen if the signals from the ceiling
sensor are insufficiently reflected due to the
ceiling geometry; for example, if there are
large window areas at a 45° angle.
In these cases, the sensitivity and the range of
the ceiling sensor system must be adjusted.
For more information, refer to the next chapter.
Changing the sensor settings
The ceiling sensor system is supplied by
STILL with the following factory settings:
Sensitivity: High
Ceiling height: 24 m
– Pull out the connecting cable from the
sensor.
56338011803 EN - 02/2019 - 09 247
www. duma -rent.com