Still RX60-25, Original Instructions Manual, Page: 201 / 470

Operation
4
Handling loads
NOTE
The method of operating the lifting system
depends on the operating devices included in
the truck's equipment.
– Ensure that the truck has been in operation
for a period of time before carrying out the
load measurement.
– Set lift mast to vertical.
– Raise the fork to a height of 300–800 mm.
– Ensure that the load is at rest.
6210_003-072_V2
2 1
– Press Softkey (1).
Load measurement is switched on.
The (2) symbol is displayed.
NOTE
If the truck is equipped with mini-levers or
fingertip operation, the
F1
button can also be
pressed as an alternative.
NOTE
During the following process, the fork carriage
must be lowered slightly and then stopped
abruptly. While doing so, the fork must
not touch the ground, otherwise the load
measurement will not be accurate. To stop
the lowering procedure quickly, release the
operating device for lowering so that it jumps
into the zero position.
– Lower the fork carriage slightly and release
the operating device.
NOTE
When stopping the lowering process the
load must be cushioned in order to create a
measurable impulse.
56338011803 EN - 02/2019 - 09 187
www. duma -rent.com