Still RX60 25-35, Original Instructions Manual

Page: 289 / 518

The following message appears:
Disengage
all hydraulic axles, then
switch off the truck
–
Depressurise the hydraulics; see the corre-
sponding section.
WARNING
The movements of the load lift system present a risk
of crushing.
During the depressurisation process, the fork car-
riage or the lift mast can move slightly.
–
Do not reach into or stand below the components
of the load lift system.
NOTE
Do not move the steering wheel while de-
pressurising the hydraulics. Otherwise the hy-
draulic system will build up pressure again. As
soon as pressure has built up in the hydraulic
system again, the function for relieving the hy-
draulics becomes inactive.
Depressurising the hydraulic sys-
tem using multi-lever operation
–
Start the "wizard for depressurising the hy-
draulic system".
Depressurising the hydraulic circuits for
the basic functions
The basic functions include the first four hy-
draulic functions. The basic functions are con-
trolled via the first two hydraulic circuits.
The basic functions are:
●
Lifting the fork carriage
●
Lowering the fork carriage
●
Tilting the lift mast forwards
●
Tilting the lift mast backwards
–
Push the operating levers (1, 2) once in the
direction of the arrow until the end position
is reached.
The hydraulic circuits of the basic functions
are now depressurised.

6219_003-251
1
2

Operating
4
Depressurising the hydraulic system
275 56378011526 EN - 03/2021 - 01