Still RX60 25-35, Original Instructions Manual

Page: 276 / 518

When the combination of load weight and
load centre of gravity exceeds the speci-
fied value, the display moves into the red
area.
The dynamics of the lifting movements
and tilting movements are significantly re-
duced.
–
In this case, set down the load or tilt back-
wards.
If a sensor belonging to Dynamic Load Con-
trol 2 fails, the level of intervention from the
function is increased to a maximum. A cross
appears instead of the bar.
–
If this display appears permanently, contact
the authorised service centre.
Load measurement (variant)
Knowing the weight of the load to be transpor-
ted gives the driver greater security. If the
truck is equipped with the "load measurement"
assistance system, the weight of the lifted load
is measured and displayed in the display-op-
erating unit (1). The measuring accuracy is
5% of the rated capacity.
–
Observe the following safety information.
DANGER
Risk of accident from a falling load!
The load may fall if the load centre of gravity has not
been taken into account or the load has not been
picked up securely.
–
Pick up the load securely; see the chapter entitled
"Picking up loads".

6219_003-112_V4
1,6 t
2,71
m
7,0°

Operating
4
Load-dependant assistance systems
262 56378011526 EN - 03/2021 - 01