Still RX60 25-35, Original Instructions Manual

Page: 235 / 518

–
If the load programs are saved as a favour-
ite on a softkey, press the softkey until
the number of the desired load program is
shown on the display.
The number of dynamic bar segments shows
the load dynamics of the selected load pro-
gram.
Limiting the load dynamics to load program 1
during the warm-up phase
NOTE
During the warm-up phase, the load dynamics
are limited to load program 1. The adjacent
symbol appears on the display until the warm-
up phase is complete.
–
Refer to the section entitled "Warming up
the hydraulic oil at cold ambient tempera-
tures" in the chapter entitled "Operation —
Checks and tasks before daily use."
Fork wear protection (variant)
The "fork wear protection" variant ensures that
the fork arms do not touch the ground. The
fork arms are protected against wear and the
building floor is protected against damage.
The lift cylinders have in-built fixed stops to
prevent the fork arms from hitting the ground.
The lower stop makes inserting the forks into
a pallet more comfortable.
The driver cannot adjust the fork wear protec-
tion manually. However, the fork wear

6219_003-312

Operating
4
Lifting
221 56378011526 EN - 03/2021 - 01