Still RX60 25-35, Original Instructions Manual

Page: 143 / 518

Pre-Shift Check
Description of the Pre-Shift Check
(variant)
The Pre-Shift Check is a guided dialogue in
the display-operating unit. It also helps the
driver conduct the necessary "visual inspec-
tions and function checking" before everyday
use. After the truck has been switched on, the
driver must answer questions about the condi-
tion of the forklift truck with "
Yes
" or "
No
".
While the driver is doing this, the truck func-
tions are available with restrictions. The driv-
ing speed and hydraulic functions are restric-
ted.
To commission the truck, the authorised serv-
ice centre can compile the Pre-Shift Check
from a question catalogue in consultation with
the fleet manager. If a question catalogue has
not been compiled, the only question stored
by default is "Truck ready for operation?"
The authorised service centre can then restrict
the truck functions in the event of a negative
test result.
There are fixed responses:
●
No response
●
Speed limitation
●
Restriction of hydraulics to 33%
In addition, the fleet manager has the follow-
ing options:
●
The fleet manager can view the results of
all checks via the "
History
".
●
The fleet manager can define the shift start
for three different shifts. The Pre-Shift
Check must be performed when these shifts
start.
If the truck is equipped with "FleetManag-
er", the shifts are defined on the FleetMan-
ager interface. See the relevant operating
instructions.
●
If, due to a negative test result, truck func-
tions are restricted, the fleet manager can
reset these restrictions.
●
The fleet manager can specify the question
sequence.
Operating
4
Pre-Shift Check
129 56378011526 EN - 03/2021 - 01