Still RX60 25-35, Original Instructions Manual

Page: 116 / 518

Operating the pneumatic signal
horn
The signal horn is used to warn people
against imminent danger or to announce your
intention to overtake.
Depending on the application and configura-
tion, the truck is equipped with a pneumatic
signal horn.
To ensure that the signal horn sounds, the air
must be pressed out of a bellows on the bot-
tom plate and into the signal horn.
–
Press the bellows (1) using your left foot.
The signal horn sounds.
Using the driver's cab
DANGER
Risk of explosion due to static charge!
Depending on the version, non-conduc-
tive parts (plastic parts) on the truck
must be painted using a special antistat-
ic paint. This paint prevents the parts
from building up an electrostatic charge.
Otherwise, static discharge may occur,
resulting in explosions in the surrounding
atmosphere in potentially explosive
areas.
The non-conductive parts of the cab
(variant) must also be covered with anti-
static materials or coated with antistatic
paint.
–
Only drive into potentially explosive
areas if the cab or fabric-covered cab
complies with explosion protection di-
rectives.
NOTE
If the plastic parts on the truck are not equip-
ped with special antistatic paint, decal infor-
mation is attached to the non-conductive
parts: "Non-conductive parts - risk of electro-
static charge - only clean using a damp cloth"
5063_003-006
1

Operating
4
Checks and tasks before daily use
102 56378011526 EN - 03/2021 - 01