Still RX60-16, Original Instructions Manual

Page: 186 / 412

5
Operation
Working with attachments
Load capacity with attachment
The permissible load capacity of the attach-
ment and the allowable load (load capacity
and load moment) of the truck must not be ex-
ceeded by the combination of attachment and
payload. The specifications of the manufac-
turer and supplier of the attachment must be
complied with.
– Observe the residual load capacity rating
plate, see the chapter entitled "Taking up a
load using attachments".
7090_900-001
Releasing the pressure from the
hydraulic system
Prior to assembling attachments, the plug
connectors must be depressurised.
Attachments must only be installed by au-
thorised personnel in accordance with the
information provided by the manufacturer and
supplier of the attachments. After each instal-
lation, the attachment must be checked for
correct function prior to initial commissioning.
NOTE
The pressure release procedure is dependent
on the operating devices for controlling the
hydraulic functions; see the chapter entitled
"Lifting system operating devices".
2060_003-018
Depressurisation, multi-lever
– Switch on the key switch.
– Lower the fork carriage to the ground.
– Tilt the lift mast back to the stop
– Switch off the key switch.
– Actuate the operating lever for controlling
the hydraulic functions repeatedly in the
direction of the arrow as far as the end
position
NOTE
The number of operating levers shown may
differ from the truck’s equipment.
174 170525 EN - 10/2016