Still RX60-16, Original Instructions Manual

Page: 118 / 412

5
Operation
Driving
Roadways
Dimensions of roadways and aisle widths
The following dimensions and aisle width
requirements apply under the specified
conditions to ensure safe manoeuvring. In
each case, a check must be performed to
determine whether a larger aisle width is
necessary, e.g. in the case of deviating load
dimensions, attachments, lift masts, trailer
couplings.
Within the EU, Directive 89/654/EEC (mini-
mum safety and health requirements for the
workplace) must be observed. The respective
national guidelines apply for areas outside of
the EU.
The required aisle widths depend on the
dimensions of the load.
For pallets, these are:
Aisle width [mm]
Model
Type
With pallet
1000x1200
crosswise
With pallet
800x1200
lengthwise
RX60-16
(6311)
3408 3607
RX60-18
(6313)
3439 3638
RX60-20
(6315)
3449 3648
The truck may only be used on roadways
that do not have excessively sharp bends,
excessively steep gradients or excessively
narrow or low entrances.
Driving on gradients
WARNING
Driving up and down longer gradients may cause
the drive unit to overheat and switch off.
Driving up and down longer gradients is not permit-
ted due to the minimum specified braking values.
The climbing capability values given below only ap-
ply to overcoming obstacles on the roadway and to
short differences in level, e.g. ramps.
The truck may be driven on the following
upwards or downwards slopes:
106 170525 EN - 10/2016