Still RX50-10, Original Instructions Manual

Page: 318 / 374

6
Maintenance
Safety regulations for maintenance
Safety regulations for maintenance
General information
To prevent accidents during maintenance and
repair work, all necessary safety measures
must be taken, e.g.:
– Apply the parking brake.
– Turn off the key switch and remove the key.
– Disconnect the battery male connector.
– Ensure that the truck cannot move uninten-
tionally or start up inadvertently.
– If required, have the truck jacked up by the
authorised service centre.
– Have the raised fork carriage or the ex-
tended lift mast secured against accidental
lowering by the authorised service centre.
– Insert an appropriately sized wooden beam
as an abutment between the lift mast and
the cab, and secure the lift mast to prevent
it tilting backwards unintentionally.
– Observe the maximum lift height of the lift
mast, and compare the dimensions from
the technical data with the dimensions of
the hall into which the truck is to be driven.
These steps are taken to prevent a collision
with the ceiling of the hall and to avoid any
damage caused as a result.
Working on the hydraulic equipment
The hydraulic system must be depressurised
prior to all work on the system.
Working on the electrical equipment
Work may only be performed on the electrical
equipment of the truck when it is in a voltage-
free state. Function checks, inspections
and adjustments on energised parts must
only be performed by trained and authorised
persons, taking the necessary precautions
into account. Rings, metal bracelets etc.
must be removed before working on electric
components.
306 55048011501 EN - 12/2015