Still KANVAN-05, Original Instructions Manual

Page: 26 / 164

2
Introduction
Residual risks
The manufacturer is not held responsible for
accidents involving the truck caused by the
failure of the operating company to comply
with these regulations either intentionally or
carelessly.
Stability
The stability of the truck has been tested to
the latest technological standards and is
guaranteed if the truck is used properly and
according to its intended purpose. These
standards only take into account the static
and dynamic tipping forces that can arise
during specified use in accordance with the
operating rules and intended purpose. The
risk of exceeding the moment of tilt that arises
from improper use or incorrect operation
cannot be excluded in extreme cases, and
will impact stability.
The risks can include:
• loss of stability due to unstable or sliding
loads etc.
• cornering at excessive speeds,
• moving with the load raised,
• moving with a load that is protruding to the
side (e.g. sideshift),
• turning and driving diagonally across
slopes,
• driving on slopes with the load on the
downhill side,
• loads that are too wide,
• swinging loads,
• ramp edges or steps.
Special risks arising from use of the
truck and its accessories
Consult the manufacturer or the relevant
work safety authority if you use your truck
for works outside normal use or if the operator
is uncertain of the correct use and compliance
with the safety regulations. In particularly
difficult cases, the person responsible for
manoeuvring must be present at the site
of the operation to direct and supervise the
manoeuvres.
18 50108043033 [EN]